Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 34

ztd cancel Stops ZTD while in progress. After you cancel ZTD, you can enter CLI commands to configure the switch. Syntax Parameters Default Command Mode Usage Information Example ztd cancel None ZTD is enabled. EXEC When ZTD is enabled, the command-line interface is locked. You cannot enter OS10 configuration commands. Use the ztd cancel command to cancel the ZTD process and return to CLI configuration mode. You can enter ztd cancel only when ZTD is in a waiting state; that is, before it receives an answer from the DHCP server. Otherwise, the command returns an error message. OS10# ztd cancel Supported Releases 10.4.1.0 or later Remote access You can remotely access the OS10 command-line interface (CLI) and the Linux shell. When you install OS10 the first time, connect to the switch using the serial port. Configure remote access • Configure the Management port IP address • Configure a default route to the Management port • Configure a user name and password Remote access OS10 CLI 1 Open an SSH session using the IP address of the device. You can also use PuTTY or a similar tool to access the device remotely. ssh admin@ip-address password: admin 2 Enter admin for both the default user name and password to log into OS10. You are automatically placed in EXEC mode. OS10# Remote access Linux shell ssh linuxadmin@ip-address password: linuxadmin Configure Management IP address To remotely access OS10, assign an IP address to the management port. The management interface is used for OOB management purposes. 1 Configure the management interface from CONFIGURATION mode. interface mgmt 1/1/1 2 By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode. no ip address dhcp 34 Getting Started