Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 757

PG-grp Priority# Bandwidth TSA 0 0,1,2,3 70% ETS 1 4,5,6,7 30% ETS 2 0% SP 3 0% SP 4 0% SP 5 0% SP 6 0% SP 7 0% SP 15 0% SP Oper status is init ETS DCBX Oper status is Up State Machine Type is Feature Conf TLV Tx Status is enabled Reco TLV Tx Status is disabled 220 Input Conf TLV Pkts, 396 Output Conf TLV Pkts, 0 Error Conf TLV Pkts DCBX commands dcbx enable Enables DCBX globally on all port interfaces. Syntax Parameters Default Command Mode Usage Information Example dcbx enable None Disabled CONFIGURATION DCBX is disabled at a global level and enabled at an interface level by default. For DCBX to be operational, DCBX must be enabled at both the global and interface levels. Enable DCBX globally with the dcbx enable command to activate the exchange of DCBX TLV messages with PFC, ETS, and iSCSI configurations. Use DCBX interfacelevel commands to configure the TLVs advertised by a DCBX-enabled port, change the DCBX version, or disable DCBX on an interface. DCBX allows peers to advertise DCB configuration using LLDP and self-configure with compatible settings. If you disable DCBX globally on a switch, you can re-enable it to ensure consistent operation of peers in a converged data center network. OS10(config)# dcbx enable Supported Releases 10.3.0E or later dcbx tlv-select Configures the DCB TLVs advertised by a DCBX-enabled port. Syntax dcbx tlv-select {[ets-conf] [ets-reco] [pfc]} Parameters • ets-conf - Advertise ETS configuration TLVs. • ets-reco - Advertise ETS recommendation TLVs. • pfc - Advertise PFC TLVs. Converged data center services 757