Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 144

fibrechannel1/1/30:3 Supported Releases 10.3.1E or later vfabric Configures a virtual fabric (vfabric). Enable the F_Port before configuring a vfabric. You can configure only one vfabric in F_Port mode. The vfabric becomes active only when you configure the vfabric with a valid VLAN and FC map. Do not use spanned VLAN as vfabric VLAN. Syntax vfabric fabric-ID Parameters fabric-ID - Enter the fabric ID, from 1 to 255. Defaults Not configured Command Mode CONFIGURATION Usage Information The no version of this command removes the vfabric. You can remove a vfabric only when it is not applied on any interfaces. Example OS10(config)# vfabric 100 Supported Releases 10.3.1E or later vfabric (interface) Applies an existing vfabric to an Ethernet or FC interface. Syntax Parameters Defaults Command Mode Usage Information vfabric fabric-ID fabric-ID - Enter the fabric ID, from 1 to 255. Not configured INTERFACE The no version of this command removes the vfabric from the interface. Example OS10(config)# interface fibrechannel 1/1/1 OS10(conf-if-fc1/1/1)# vfabric 100 OS10(config)# interface ethernet 1/1/10 OS10(conf-if-eth1/1/10)# vfabric 200 Supported Releases 10.3.1E or later vlan Associate an existing VLAN ID to the vfabric to carry traffic. Create the VLAN ID before associating it to the vfabric. Do not use spanned VLAN as vfabric VLAN. Syntax Parameters vlan vlan-ID vlan-ID - Enter an existing VLAN ID. 144 Fibre Channel