Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 438
Assign Router ID, Stub Areas, The Type 5 LSAs are
![]() |
View all Dell PowerSwitch S4128F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 438 highlights
3 Enable (or bring up) the interface in INTERFACE mode. no shutdown 4 Disable the default switchport configuration and remove it from an interface or a LAG port in INTERFACE mode. no switchport 5 Enable the OSPFv3 on an interface in INTERFACE mode. ipv6 ospfv3 process-id area area-id • process-id - Enter the OSPFv3 process ID for a specific OSPFv3 process (1 to 65535). • area-id - Enter the OSPF area ID as an IP address (A.B.C.D) or number (1 to 65535). Enable OSPFv3 OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# exit OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# no shutdown OS10(conf-if-eth1/1/1)# no switchport OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0 Assign Router ID You can assign a router ID for the OSPFv3 process. Configure an arbitrary value in the IP address format for each router. Each router ID must be unique. Use the fixed router ID for the active OSPFv3 router process. Changing the router ID brings down the existing OSPFv3 adjacency. The new router ID becomes effective immediately. • Assign the router ID for the OSPFv3 process in ROUTER-OSPFv3 mode. router-id ip-address Assign router ID OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# router-id 10.10.1.5 View OSPFv3 Status OS10# show ipv6 ospf Routing Process ospfv3 100 with ID 10.10.1.5 It is an Area Border Router Min LSA origination 5000 msec, Min LSA arrival 1000 msec Min LSA hold time 0 msec, Max LSA wait time 0 msec Number of area in this router is 2, normal 2 stub 0 nssa Area (0.0.0.0) Number of interface in this area is 1 SPF algorithm executed 42 times Area (0.0.0.1) Number of interface in this area is 1 SPF algorithm executed 42 times Configure Stub Areas The Type 5 LSAs are not flooded into stub areas. The ABR advertises a default route into the stub area to which it is attached. Stub area routers use the default route to reach external destinations. 1 Enable OSPFv3 routing and enter ROUTER-OSPFv3 mode (1 to 65535). router ospfv3 instance number 2 Configure an area as a stub area in ROUTER-OSPFv3 mode. area area-id stub [no-summary] • area-id - Enter the OSPFv3 area ID as an IP address (A.B.C.D) or number (1 to 65535). 438 Layer 3
![](/manual_guide/products/dell-powerswitch-s3048on-os10-enterprise-edition-user-guide-release-10410-b76d862/438.png)