Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 782

Usage Information The no version of this command to disables sFlow. Example (interface) OS10(config)# sflow enable OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# sflow enable Example (interface range) OS10(config)# sflow enable OS10(config)# interface range ethernet 1/1/1-1/1/10 OS10(conf-range-eth1/1/1-1/1/10)# sflow enable Example (portchannel) OS10(config)# sflow enable OS10(config)# interface range port-channel 1-10 OS10(conf-range-po-1-10)# sflow enable Supported Releases 10.3.0E or later sflow max-header-size Sets the maximum header size of a packet. Syntax sflow max-header-size header-size Parameter header-size - Enter the header size in bytes, from 64 to 256. The default is 128. Default 128 bytes Command Mode CONFIGURATION Usage Information Example Use the no version of the command to reset the header size to the default value. OS10(conf)# sflow max-header-size 256 Supported Releases 10.3.0E or later sflow polling-interval Sets the sFlow polling interval. Syntax sflow polling-interval interval-value Parameter interval-value - Enter the interval value in sections, from 10 to 300. The default is 30. Defaults 30 Command Mode CONFIGURATION Usage Information The polling interval for an interface is the number of seconds between successive samples of counters sent to the collector. You can configure the duration for polled interface statistics. The no version of the command resets the interval time to the default value. Example OS10(conf)# sflow polling-interval 200 Supported Releases 10.3.0E or later 782 sFlow