Dell PowerSwitch S4128F-ON OS10 Enterprise Edition User Guide Release 10.4.1.0 - Page 589

Command Mode Usage Information Example EXEC None OS10# show openflow switch of-switch-1 controllers Logical switch name: of-switch-1 Total Controllers: 1 Controller: 1 Target: 10.16.208.150:6633 Protocol: TCP Connected: NO Role: Equal Last_error: Network is unreachable State: BACKOFF sec_since_disconnect: 0 Supported Releases 10.4.1 or later switch Creates a logical switch instance or modifies an existing logical switch instance. Syntax Parameters Default Command Mode Usage Information switch logical-switch-name logical-switch-name-Enter the name of the logical switch instance that you want to create or modify, a maximum of 15 characters. OS10 supports only one instance of the logical switch. None OPENFLOW CONFIGURATION You must configure a controller for the logical switch instance. The logical switch instance is disabled by default. To establish a connection with the controller, enable the logical switch instance using the no shutdown command. All physical and logical interfaces in the switch are assigned to the configured logical switch. The no form of this command removes the logical switch instance. NOTE: OS10 supports only one instance of the logical switch. If you attempt to create a second logical switch instance, the following message appears: % Warning: Only one Switch instance is supported Example OS10# config terminal OS10 (config)# openflow OS10 (config-openflow)# switch of-switch-1 OS10 (config-openflow-switch)# no shutdown Supported Releases 10.4.1 or later OpenFlow-only mode commands When you configure the switch to OpenFlow-only mode, only the following commands are available; all other commands are disabled. OpenFlow 589