Epson ActionLaser 1500 User Manual - Page 120

0 If you are using legal-size paper, you may find that the printable area is smaller than you expect. To clear this problem, decrease the RX-BUFFER SIZE option in SelecType or increase the available RAM. See the discussion of RX-BUFFER SIZE in Chapter 4, "SelecType," or see "The Memory Chip Sets" later in this chapter. Cl If you set EMULATION to one of the Intelligent Emulation Switch (IES) settings, be sure to turn off the start page printing feature in PostScript. If both the IES feature and the start page printing feature are on, the printer prints the start page each time it switches from HP emulation to PostScript. Epson GL identity card Follow these guidelines when using the optional Epson GL identity card. 0 The GL emulation requires at least 1.5 megabytes (MB) of RAM. This means you need to add at least 1.0MB RAM to an ActionLaser 1000 or 0.5MB RAM to an ActionLaser 1500 before you can use GL emulation. See "The Memory Chip Sets" later in this chapter. Cl The printer ignores device control commands from optional interfaces even if the interface is serial. Use the printer's serial interface to enable the additional device control commands. (If you have an ActionLaser 1000, use your parallel interface.) 5-6 Options