Epson ActionLaser 1500 User Manual - Page 184

Note: To find out which font cards are available in HP emulation, see your dealer. For available font cartridges, see Chapter 5, "Options." After you select the font source, press A or v until the display shows the font number you want; then press ) to select the font. The font number is based on the font source option (RD, A, C, or DL) selected above. The available fonts and their numbers are listed in the SelecType Level 1 FONT SAMPLE printout. If your are using the 3/P/Si emulation and the font you select is a scalable font, you must perform an additional step as follows. If you select a proportional font, press A or v to select the font's point size. Then press b once to set that point size. Menu/submenu HEIGHT : XXPT. Available options b SET 4.00 to 999.75 (in steps of 0.25) or ****** If ****** appears on the display, the point size you selected is out of the possible range of 4.00 to 999.75. If you selected a fixed pitch font, press A or v to select the spacing in characters per inch. Then press b once to set that spacing. Menu/submenu PITCH 4 XXCPI Available options b SET 0.44 to 99.99 (in steps of 0.01) or ***** If ***** appears on the display, the spacing you selected is out of the possible range of 0.44 to 99.99. If you change the SYMSET setting, the available font numbers may change. To save the selected font as the default font, use the SAVE MACRO option in the Level 1 SYSTEM CONFIG. menu. HP Emulation Mode B-7