Epson ActionLaser 1500 User Manual - Page 223
Two modes of Epson GL/2, QLJ3-GL/2 mode PGL-like mode
View all Epson ActionLaser 1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
Two modes of Epson GL/2 Epson GL/2 mode has two operational modes. One is the LJ3-GL/2 mode, another is the GL-like mode. Q LJ3-GL/2 mode This mode emulates GL/2 mode of the HP LaserJet series III emulation. While in this mode you can enter GL/2 mode without sending the ESC %#B (Enter GL/2 mode) command. If your application software cannot send the ESC %#B command, then use this mode. If your application software supports LaserJet series printers, you do not need to use this mode. P GL-like mode This mode emulates some of the HP-GL® plotter commands. It features all of the commands of the LJ3-GL/2 mode, plus two additional commands. The table below shows the differences of these modes. IPrintable areas (Picture frame) Default position of P1 and P2 Undefined commands CS, CA commands Results when the DT command without second parameter is sent LJ3-GL/2 mode 1/1016 inch Same as LaserJet Ill mode Lower left and upper right corners respectively of picture frame First character is ignored Not supported Terminator is not plotted l The area of hard-clip limit is on the next page. GL-like mode 1/1021 inch Depends on the hard-clip limit' Inside of picture frame First two characters are ignored Partially supported Terminator is plotted B-46 HP Emulation Mode