Epson ActionLaser 1500 User Manual - Page 96
Full Print, Et F U Lp Ri Nt, Set Full Prlnt
View all Epson ActionLaser 1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
FULL PRINT This Level 1 option is a submenu of SYSTEM CONFIG. The default setting of 0 is sufficient for most uses of the printer. If the printer displays the message S ET F U L L P RI NT, increase this setting. The setting (any number from 0 through 62) times 20 is the number of kilobytes (KB) reserved in RAM for page composition. For example, a setting of 5 reserves 100KB. Menu/submenu 4 FULL PRINT Available options 0 b 0 to 62 The following table shows the maximum setting necessary for each size of paper. The setting may be lower than the maximum, but it will never need to be higher. GLT 45 C5 38 Since the amount of RAM you reserve with this option is not available for any other purpose, it is best to leave the setting at 0 until you see a SET FULL PRlNT message. Then, increase the setting in small increments until the error does not occur. 4-12 SelecType