Epson R260 Service Manual - Page 100
Reinstalling the EJ Frame Assy
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 3. Disengage the connector cables of the PE Sensor and the APG Sensor from the two hooks (A). 4. Remove the two screws and remove the Cable Holder Frame from the two hooks (B). • Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) Cable Holder Frame 2 1 : Hook A : Hook B PE Sensor Cable APG Sensor Cable Figure 4-128. Removing the Cable Holder Frame 5. Remove the left and right screws, and remove the Front Frame. • Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) Removal Direction Front Frame 1 2 Figure 4-129. Removing the Front Frame 6. Remove the EJ Frame Assy. Revision B Removal Direction EJ Frame Assy Figure 4-130. Removing the EJ Frame Assy Lubrication is required. See the page given below for the lubrication information. "6.1.3 Lubrication (p.131)" When installing the EJ Frame Assy, insert its two lower bushings over the EJ Roller Shaft. EJ Frame Assy Bushing Bushing EJ Roller Shaft Figure 4-131. Reinstalling the EJ Frame Assy When installing the EJ Frame, make sure that the Left/Right EJ Frame Springs are attached as shown in the figure below. Carefully handle the EJ Frame as the springs come off easily. Shorter Left EJ Frame Spring Right EJ Frame Spring Figure 4-132. Reinstalling the Front Frame (1) Longer Disassembly/Assembly Disassembly of the Printer Mechanism 101
![](/manual_guide/products/epson-r260-service-manual-02311bf/100.png)