Epson R260 Service Manual - Page 81
Removing the Card Board (R360/R380/R390 only), R260/R265
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 4.3.4 Removing the Card Board (R360/R380/R390 only) Parts/Components need to be removed in advance All exterior parts/components / Main Board Unit Card Board Removal CHECK P O IN T R360/R380/R390 are equipped with a Card Board. Remove the Card Board after removing the Main Board. Refer to R260/R265/ R270 & R360/R380/R390 Disassembly Flowchart(p.64). 1. Remove the FFC Holder. (See FFC Holder removal on page 76) 2. Remove the five screws and remove the Card Board. • Screw : C.B.S. M3x10 (tightening torque: 5-7 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) 1 4 3 5 2 Card Board Figure 4-64. Removing the Card Board Revision B Card Board disassembly 1. Disconnect the FFC from CN1 connector on the Card Board. 2. Remove the screw and remove the Ground Plate CB. • Screw : C.B.S. M3x6 (tightening torque: 5-7 kgf.cm) CN1 Ground Plate CB Figure 4-65. Card Board Disassembly To match the FFC to the position of the Ferrite Core, twist and fold the Head FFC as shown in the figure, then route it through the Ferrite Core. Head FFC Figure 4-66. Routing the Head FFC (1) Screw the Card Board in the order given in Fig.4-64. Disassembly/Assembly Removing Control Boards 82
![](/manual_guide/products/epson-r260-service-manual-02311bf/81.png)