Epson R260 Service Manual - Page 87
EPSON Stylus Photo R260/R265/R270, R360/R380/R390, Revision B, Disassembly/Assembly, Removing the Printer Mechanism
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 2. Remove the six screws that secure the Printer Mechanism. • Screw : C.B.P. M3x8 (tightening torque: 7-9 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) 6 [Left side] [Right side] Revision B Before installing the Printer Mechanism, make sure that the cables are correctly routed referring to the figure below and the following pages. 1 2 5 4 3 2 3 1 Figure 4-86. Removing the Screws (Printer Mechanism) 3. Referring to ""Figure 4-82. Handling the Printer Mechanism (p.87)"", remove the Printer Mechanism from the Lower Housing. When installing the Printer Mechanism, be extremely careful not to let the cables at the left front side get caught under the Printer Mechanism. Tighten the screws in the order given in Fig.4-86. Figure 4-87. Routing the cables prior to Printer Mechanism installation 1. "Removing the Connector Cables of the P/S Assy" (p.94) 2. "Routing of the PF Motor cables" (p.103) 3. "Routing of the PF Motor cables" (p.103) "Routing of the APG and PE Sensor Cables." (p.102) A D JU S TM E N T R E Q U IR E D Whenever the Printer Mechanism is replaced, the required adjustments must be carried out. •See "Table 5-4. Adjustment Items (p.116)" in Chapter 5 Disassembly/Assembly Removing the Printer Mechanism 88
![](/manual_guide/products/epson-r260-service-manual-02311bf/87.png)