Epson R260 Service Manual - Page 103
ASF Unit, Removing the LD Roller Guide 2
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 4.5.11 ASF Unit Parts/Components need to be removed in advance All exterior parts/ All control boards / Middle Housing / Printer Mechanism / Ink System Removal procedure CHECK P O IN T Refer to the Orientation Definition below for the directions indicated in the following procedures. "4.1.6 Orientation Definition (p.61)" Removing the LD Roller Guide 1. Move the CR Unit to the left (the opposite side to the home position). 2. Remove the screw that secures the LD Roller Guide. • Screw : C.B.S. (P4), M3x6 (tightening torque: 7-9 kgf.cm) 3. Push the tabs on the right and the left, slide the LD Roller Guide upward to remove it disengaging the five hooks. Tab Hook Hook Removal Direction LD Roller Guide Revision B 4. Remove the Torsion Spring 137.7 from the LD Roller Guide. Torsion Spring LD Roller Guide Figure 4-140. Removing the LD Roller Guide (2) Removing the ASF Assy 5. Remove the two screws on the rear side. • Screw : C.B.S.(P4), M3x6 (tightening torque: 7-9 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) [Rear side] 1 2 ASF Unit Figure 4-141. Removing the Screws (ASF Unit) 6. Remove the hooks (1), (2) and the tip of the Change Lever that secure the ASF Unit from the Main Frame. Hook (1) Change Lever Hook (2) Figure 4-139. Removing the LD Roller Guide (1) Figure 4-142. Disengaging the Hooks (ASF Unit) Disassembly/Assembly Disassembly of the Printer Mechanism 104