Epson R260 Service Manual - Page 82
Disassembling the Panel Unit, Removing the Panel Board for R360/R380/R390
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 4.3.5 Disassembling the Panel Unit Panel Board removal C A U T IO N Be careful not to scratch or damage the exterior surface (coated or decorative laminated parts) during disassembly and reassembly. Revision B Removing the Panel Board (for R360/R380/R390) 1. Peel off the acetate tape. 2. Disengage the Ferrite Core from the hook. Ferrite core Ferrite core CHECK P O IN T Since the R260/R265/R270 are not equipped with a LCD panel, the removal procedure of the Panel Board differs from that of the R360/R380/R390. The procedure for the R260/R265/R270 is given on the page below. •Removing the Panel Board (for R260/R265/R270) on page 84 Removing the Right/Left Laminated Panels (R360/R380/R390 only) 1. Disengage the four hooks on the rear side of the Panel Unit. 2. Push section of the Left Laminated Panel as indicated with the arrow to disengage the tabs, and remove it. 3. Remove the Right Laminated Panel in the same manner. [Rear side] [Front side] : Hooks : Tabs Acetate tape Hook Figure 4-68. Removing the Panel Board (1) 3. Disconnect the FFCs from CN1 connector on the Panel Board and CN1 connector on the LCD Board. 4. Remove the six screws, taking care not to damage the cables connecting the two Panel Boards, remove the Shield Plate PNL in the direction of the arrow. • Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm) : Positioning section Cables connecting the two Panel Boards. CN1 Removal Direction CN1 Shield Plate PNL Figure 4-69. Removing the Panel Board (2) Laminated Panel (L) Laminated Panel (R) Figure 4-67. Removing the Left/Right Laminated Panels Disassembly/Assembly Removing Control Boards 83
![](/manual_guide/products/epson-r260-service-manual-02311bf/82.png)