Epson R260 Service Manual - Page 76
EPSON Stylus Photo R260/R265/R270, R360/R380/R390, Revision B, Disassembly/Assembly, Removing Control Boards
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 3. From the rear side, push the positioning pin out with a screw driver or similar tool, and slide the FFC Holder upward to remove it from the Middle Housing. FFC Holder Removal Direction Push Screw driver Positioning Pin FFC Holder Figure 4-47. Removing the FFC Holder (1) 4. Straighten the fold of the Head FFC, and remove the FFC Holder pulling the FFC out from the Ferrite Core. FFC Holder Ferrite core Straighten the Head FFC and pull it out from the Ferrite Core Figure 4-48. Removing the FFC Holder (2) When installing the FFC Holder, make sure to secure it with the three hooked tabs and insert the positioning pin shown in Fig.4-47. : Hooked tab Revision B When putting the Head FFC through the Ferrite Core, first straighten the fold of the pair of two FFCs, then put the five FFCs through the Ferrite Core one by one taking care not to damage them. Then, route the FFCs after folding the pair of two FFCs as they were (fold at shown in the figure). Head FFC (front) Head FFC (back) Figure 4-50. Routing the Head FFC (2) Screw the USB Board in the order given in Fig.4-44. When screwing the USB Board, secure the GND Cable of the USB Cable together with the screw as shown in Fig.4-44. FFC Holder Figure 4-49. Reinstalling the FFC Holder Disassembly/Assembly Removing Control Boards 77
![](/manual_guide/products/epson-r260-service-manual-02311bf/76.png)