Epson R260 Service Manual - Page 69
EMI Frame / Waste Ink Tray, 4.1.8 Sharp Metal Edges Danger! p.62
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 4.2.7 EMI Frame / Waste Ink Tray Parts/Components need to be removed in advance Paper Support / Printer Cover / Front Cover / Right Housing / Left Housing / USB Housing / Upper Housing / Panel Unit Removal procedure C A U T IO N Take extra care to avoid injury from sharp metal edges. Before starting, see the page given below to check the dangerous edges. •"4.1.8 Sharp Metal Edges (Danger!) (p.62)" CHECK P O IN T See the section given below on how to unlock the carriage. •"4.1.7 How to Unlock the Carriage (p.62)" EMI Frame Removal 1. Unlock the carriage and move the CR Unit to the center. 2. Remove the two screws and remove the EMI Frame. • Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm) Danger! Sharp Edge! EMI Frame [Right side] Figure 4-26. Removing the EMI Frame Revision B Follow the procedure below to install the EMI Frame. 1. Insert (1) portion between the Shield Plate and the Main Frame. (R360/R380/R390 only) 2. Insert the bottom edge of the EMI Frame into the notch of the Waste Ink Tray. 3. Insert the positioning hole (2) over the guide pin on the main frame. 4. Tighten the screws in the order of (1) and (2). EMI Frame 1 Notch Positioning Hole 2 Guide Pin Figure 4-27. Reinstalling the EMI Frame Disassembly/Assembly Removing Exterior Parts/Components 70
![](/manual_guide/products/epson-r260-service-manual-02311bf/69.png)