Epson R260 Service Manual - Page 64
Removing Exterior Parts/Components, 4.2.1 Paper Support, 4.2.2 Printer Cover, Paper Support
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 4.2 Removing Exterior Parts/Components 4.2.1 Paper Support Parts/Components need to be removed in advance: Nothing Removal procedure 1. Open the Paper Support. 2. Disengage the right shaft of the Paper Support from the bushing of the ASF Unit by pushing the bushing outward. Then remove the Paper Support, disengaging the left shaft preventing the Edge Guide projection from hitting against the other parts. Paper Support Edge Guide Projection Revision B 4.2.2 Printer Cover Parts/Components need to be removed in advance: Nothing Removal procedure 1. Open the Printer Cover. 2. Pull out the left shaft and right shaft of the Printer Cover in that order, and remove the Printer Cover. Printer Cover Shaft (right) Push Bushing of the ASF : Shaft Figure 4-11. Removing the Paper Support l When reinstalling the Paper Support, match the projection and hole of the Edge Guide, then attach the right shaft and the left shaft in that order. (Put the shafts at the front side in the bushing and then push them rearward.) After reinstalling, check that the Paper Support moves smoothly. Paper Support Projection 2 1 Mounting Direction (from front side to rear side) Hole : Shaft Figure 4-12. Reinstalling the Paper Support Shaft (left) Figure 4-13. Removing the Printer Cover (1) When an instruction label needs to be attached, attach it aligning with the line marked on the back of the Printer Cover. Make sure it is in the correct orientation as shown below. Instruction Label Marking Figure 4-14. Attaching the Instruction Label Disassembly/Assembly Removing Exterior Parts/Components 65
![](/manual_guide/products/epson-r260-service-manual-02311bf/64.png)