Epson R260 Service Manual - Page 83
Removing the Panel Board for R260/R265/R270
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 5. Remove the screw and remove the Panel Board. • Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm) • Positioning Hole: /Rib: Panel Board Revision B 8. Peel off the double-sided tape and remove the two FFCs from the Shield Plate PNL. • Double-sided tape: Shield Plate PNL FFC (1) FFC (2) Figure 4-70. Removing the Panel Board (3) 6. Remove two screws and remove the LCD Panel and the Ground Plate LCD. • Screw : C.B.P. M2x6 (tightening torque: 2-3 kgf.cm) LCD Panel Ground Plate LCD Figure 4-71. Removing the LCD Panel 7. Remove the SW Button (1) to (9) and the LED Light Guide Plate. 8 1 2 45 6 3 7 9 LED Light Guide Plate Figure 4-72. Removing the SW Buttons Figure 4-73. Removing the FFC Removing the Panel Board (for R260/R265/R270) 1. Remove the four screws and disengage the hook ( ) and remove the Panel Board Assy. • Screw : C.B.P. M3x8 (tightening torque: 7-9 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) 1 4 Panel Board Assy 3 2 Figure 4-74. Removing the Shield Plate PNL (R260/R265/R270) 2. Disconnect the FFC from CN1 connector on the Panel Board. 3. Remove two screws and remove the Panel Board from the Shield Plate PNL. • Screw : C.B.S. M3x6 (tightening torque: 4-6 kgf.cm) (The numbers shown in the figure indicate the order of tightening the screws.) 1 2 CN1 Shield Plate PNL FFC Panel Board Figure 4-75. Removing the Panel Board (R260/R265/R270) Disassembly/Assembly Removing Control Boards 84
![](/manual_guide/products/epson-r260-service-manual-02311bf/83.png)