Epson R260 Service Manual - Page 125
PFP Adjustment
![]() |
UPC - 010343859043
View all Epson R260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Scanning the BRS Adjustment Pattern 5. Set the printed pattern and the PFP Base Scale on the document table and click the [Scan] button on the "3. Scan Test Pattern" column. 6. According to the scanned result, BRS calibration values are automatically calculated and are written to the serial flash ROM. If an error occurs, check that the document table glass and the scale is clean, and the scale/adjustment pattern is not tilted, then repeat from step 5. C A U T IO N Be careful of the following when setting the PFP Base Scale, and the adjustment pattern on the scanner. Place the scale on the document glass aligning the scale corner with the scanner origin position. Place the pattern-printed sheet along the scale as shown in the figure below. Make sure to place it parallel to the scale, with no gaps. Revision B 5.3.2.2 PFP Adjustment Printing the PFP Adjustment Pattern 1. Load 4 x 6 Premium Glossy Photo Paper on the paper support. 2. Select [PFP Adjustment] in the adjustment program. 3. Click the [Print] button on the "1. Print Test Pattern" column to print the adjustment pattern. Scanner Origin Position PFP Base Scale BRS Adjustment Pattern (A4) CHECK P O IN T Figure 5-15. PFP Test Pattern Printer Identification Code In the Adjustment program, the identification code is used to distinguish whether the printer that printed the pattern and the printer to register the adjustment value is the same. Scanner Document Table Figure 5-14. PFP Base Scale and BRS Adjustment Pattern Position (Viewed from the document glass of the scanner) Adjustment Banding Reduction System (BRS) Adjustment/ Paper Feed Amount Profile (PFP) Correction 126
![](/manual_guide/products/epson-r260-service-manual-02311bf/125.png)