HP 6120XG HP ProCurve Series 6120 Blade Switches Advanced Traffic Management G - Page 190

Quality of Service (QoS): Managing Bandwidth More Effectively Using QoS Classifiers To Configure Quality of Service for Outbound Traffic device-priority Displays the current device (IP address) priority configuration. Refer to figure 5-7 on page 5-24. dscp-map Displays mappings between DSCP policy and 802.1p priority. port-priority Displays the current source-port priority configuration. Refer to figure 5-20 on page 5-47. protocol-priority Displays the current protocol priority configuration. queue-config Displays the outbound port queue configuration information. resources Displays the resources used by the Policy Enforcement Engine. See "Monitoring Resources" in the Management and Configuration Guide for your switch. type-of-service Displays the current type-of-service priority configuration. The display output differs according to the ToS option used: ■ IP Precedence: Refer to figure 5-9 on page 5-28. ■ Diffserve: Refer to figure 5-12 on page 5-32. vlan-priority Displays the current VLAN priority configuration. Refer to figure 5-17 on page 5-43. No Override By default, the IP ToS, Protocol, VLAN-ID, and (source) port show outputs automatically list No-override for priority options that have not been configured. This means that if you do not configure a priority for a specific option, QoS does not prioritize packets to which that option applies, resulting in the No override state. 5-14