HP 6120XG HP ProCurve Series 6120 Blade Switches Advanced Traffic Management G - Page 272
fip-snooping show command, The FC-MAP index must be between 1 and 4
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 272 highlights
Converged Enhanced Ethernet on the HP ProCurve 6120XG Switch FIP Snooping fip-snooping show command Syntax: show fip-snooping Displays the fip-snooping configuration information. Default Value: None Dependency: None FIP Snooping Information FIP Snooping : Enabled FC_MAP table Index | FC-MAP 1 | 0xEFC00 (default FC_MAP) FCF_MAC table Interface | FCF_MAC Address 24 | 00059b-70f380 Figure 6-13. Output Displaying fip-snooping show Command These warning/error messages may appear when FIP Snooping is being configured. Only four FC-MAPs can be configured globally to the box. If the user tries to configure a FC-MAP index less than 1 or greater than 4, the following error message is displayed: The FC-MAP index must be between 1 and 4 If the user tries to configure a FC-MAP which has already been configured on the switch, the following error message is displayed: An entry already exists with this FC-MAP. By FC-BB5 standards, FC-MAP should be in the range 0xEFC00 - 0xEFCFF. If the user tries to configure a FC-MAP outside this range, the following error message is displayed: The FC-MAP must be in the range EFC00-EFCFF. If the user tries to remove the configured FC-MAP, the following log message is logged and displayed: Connections established using FC-MAP have been removed.. 6-23