HP 6120XG HP ProCurve Series 6120 Blade Switches Advanced Traffic Management G - Page 48

Static Virtual LANs (VLANs) Configuring VLANs To Change VLAN Support Settings This section describes: ■ Changing the maximum number of VLANs to support ■ Changing the Primary VLAN selection (See "Changing the Primary VLAN" on page 2-35.) ■ Enabling or disabling dynamic VLANs (Refer to chapter 3, "GVRP" .) 1. From the Main Menu select: 2. Switch Configuration 8. VLAN Menu ... 1. VLAN Support You will then see the following screen: Note 2-22 Figure 2-12. The Default VLAN Support Screen 2. Press [E] (for Edit), then do one or more of the following: • To change the maximum number of VLANs, type the new number (For the HP 6120G/XG, 1-256 VLANs allowed,; for the HP 6120XG, 1 - 1024 allowed; default 256). • To designate a different VLAN as the Primary VLAN, select the Primary VLAN field and use the space bar to select from the existing options. (Note that the Primary VLAN must be a static, port-based VLAN.) • To enable or disable dynamic VLANs, select the GVRP Enabled field and use the Space bar to toggle between options. (For GVRP information, refer to chapter 3, "GVRP" .) For optimal switch memory utilization, set the number of VLANs at the number you will likely be using or a few more. If you need more VLANs later, you can increase this number, but a switch reboot will be required at that time.