HP 6120XG HP ProCurve Series 6120 Blade Switches Advanced Traffic Management G - Page 53

Static Virtual LANs (VLANs) Configuring VLANs Ports A4 and A5 are assigned to both VLANs. Ports A6 and A7 are assigned only to VLAN-22. All other ports are assigned only to the Default VLAN. Figure 2-17. Example of Port-Based VLAN Assignments for Specific Ports For information on VLAN tags ("Untagged" and "Tagged"), refer to "802.1Q VLAN Tagging" on page 2-42. d. If you are finished assigning ports to VLANs, press [Enter] and then [S] (for Save) to activate the changes you've made and to return to the Configuration menu. (The console then returns to the VLAN menu.) 3. Return to the Main menu. CLI: Configuring Port-Based and Protocol-Based VLAN Parameters In the factory default state, all ports on the switch belong to the (port-based) default VLAN (DEFAULT_VLAN; VID = 1) and are in the same broadcast/ multicast domain. (The default VLAN is also the Primary VLAN. For more on this topic, refer to "The Primary VLAN" on page 2-47.) You can configure up to 255 additional static VLANs by adding new VLAN names, and then assigning one or more ports to each VLAN. The HP 6120G/XG switch accepts a maximum of 256 VLANs; the HP 6120XG switch accepts a maximum o f1024 VLANs (vids numbered up to 4094), including the default VLAN and any dynamic VLANs the switch creates if you enable GVRP. Refer to chapter 3, "GVRP" .) Note that each port can be assigned to multiple VLANs by using VLAN tagging. (See "802.1Q VLAN Tagging" on page 2-42.) 2-27