HP 6120XG HP ProCurve Series 6120 Blade Switches Advanced Traffic Management G - Page 232

Quality of Service (QoS): Managing Bandwidth More Effectively Differentiated Services Codepoint (DSCP) Mapping using qos dscp-map < codepoint > priority < 0 - 7 >. (These policies are not in effect unless you have either applied the policies to a QoS classifier or configured QoS Type-of-Service to be in diff-services mode.) Quickly Listing Non-Default Codepoint Settings Table 5-9 lists the switch's default codepoint/priority settings. If you change the priority of any codepoint setting to a non-default value and then execute write memory, the switch will list the non-default setting in the show config display. For example, in the default configuration, the following codepoint settings are true: Codepoint af11 13 af13 Default Priority 1 No-override 2 If you change all three settings to a priority of 3, and then execute write memory, the switch will reflect these changes in the show config listing: ProCurve(config)# qos dscp-map af11 priority 3 ProCurve(config)# qos dscp-map 13 priority 3 ProCurve(config)# qos dscp-map af13 priority 3 ProCurve(config)# write memory ProCurve(config)# show config Startup configuration: Configure these three codepoints with non-default priorities. ; J9146 Configuration Editor; Created on release W.14.XX hostname "ProCurve" time daylight-time-rule None qos dscp-map af11 priority 3 qos dscp-map 13 priority 3 qos dscp-map af13 priority 3 . . . Show config lists the non default codepoint settings. Figure 5-25. Example of Show Config Listing with Non-Default Priority Settings in the DSCP Table 5-56