HP Color LaserJet 9500 Service Manual - Page 160
Cable assembly
View all HP Color LaserJet 9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
Cable assembly 1 Remove the following FRUs: • Face-up bin. See page 129. • Stapler/stacker bin. See page 129. • Back inner cover. See page 130. • Back cover. See page 132. • Controller PCA cover. See page 135. 2 Disconnect the ribbon cables from the flipper assembly, the path assembly, and the controller PCA. 3 Disconnect the power cable from the power supply. 4 Loosen two screws, and then disconnect the Jet-Link cable from the controller PCA. 5 Use a Torx #20 screwdriver to loosen one screw (callout 1), and remove three screws (callout 2), and then lift the cable assembly away from the output device. 2 12 Figure 127. Cable assembly 158 Removal and replacement ENWW
158
Removal and replacement
ENWW
Cable assembly
1
Remove the following FRUs:
•
Face-up bin. See page 129.
•
Stapler/stacker bin. See page 129.
•
Back inner cover. See page 130.
•
Back cover. See page 132.
•
Controller PCA cover. See page 135.
2
Disconnect the ribbon cables from the flipper assembly, the path assembly, and the
controller PCA.
3
Disconnect the power cable from the power supply.
4
Loosen two screws, and then disconnect the Jet-Link cable from the controller PCA.
5
Use a Torx #20 screwdriver to loosen one screw (callout 1), and remove three screws
(callout 2), and then lift the cable assembly away from the output device.
Figure 127.
Cable assembly
2
2
1
2