HP Color LaserJet 9500 Service Manual - Page 161
Casters, Stationary caster, Adjustable caster
View all HP Color LaserJet 9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Casters Stationary caster 1 Lay the output device on its front or back side, so that the caster being replaced is off of the floor. 2 Use a Torx #20 screwdriver to remove one screw (callout 1) from the inside of the frame. 3 Rotate the caster 90° to clear the tabs, and then pull the caster away from the output device. 12 Figure 128. Stationary caster Adjustable caster 1 Lay the output device on its front or back side, so that the caster being replaced is off of the floor. 2 Use a flatblade screwdriver and snap the e-clip off of the adjusting knob. 3 Slide the caster out of position and remove it. Figure 129. ENWW Adjustable caster Chapter 6 Removal and replacement 159
ENWW
Chapter 6 Removal and replacement
159
Casters
Stationary caster
1
Lay the output device on its front or back side, so that the caster being replaced is off of the
floor.
2
Use a Torx #20 screwdriver to remove one screw (callout 1) from the inside of the frame.
3
Rotate the caster 90° to clear the tabs, and then pull the caster away from the output device.
Figure 128.
Stationary caster
Adjustable caster
1
Lay the output device on its front or back side, so that the caster being replaced is off of the
floor.
2
Use a flatblade screwdriver and snap the e-clip off of the adjusting knob.
3
Slide the caster out of position and remove it.
Figure 129.
Adjustable caster
2
1