HP Color LaserJet 9500 Service Manual - Page 30

Specifications Multifunction finisher Table 1. Physical specifications-multifunction finisher Specification Multifunction finisher Measurements Height: 985 mm (38.8 inches) Width: 690 mm (27.2 inches) Depth: 60 mm (23.6 inches) Weight 44.4 kg (98 lb) CAUTION Table 2. Electrical specifications-multifunction finisher Volts Amperes Frequency (amps) Watts (W) (typical) Thermal units per hour (Btu/hr) 100-127 Vac 50/60 Hz ±10% ±2 Hz Minimum recommended current capacity = 13.0 amp Printing = 1,075 W Standby = 440 W PowerSave 1 = 70 W Low power = 230 W Off = 0.5 W ADF printing = 1,130 W Printing = 3,670 Btu/hr Standby = 1,500 Btu/hr PowerSave 1 = 240 Btu/hr Low power = 785 Btu/hr Off = 1.7 Btu/hr ADF printing = 3,860 Btu/hr 220-240 Vac 50/60 Hz ±10% ±2 Hz Minimum recommended current capacity = 6.5 amp Printing = 1,075 W Standby = 440 W PowerSave 1 = 70 W Low power = 230 W Off = 1.3 W ADF printing = 1,130 W Printing = 3,650 Btu/hr Standby = 1,420 Btu/hr PowerSave 1 = 240 Btu/hr Low power= 785 Btu/hr Off = 4.5 Btu/hr ADF printing = 3,670 Btu/hr Power requirements are based on the country/region where the output device is sold. Do not convert operating voltages. This can damage the output device and void the product warranty. Table 3. Environmental specifications-multifunction finisher Condition Operating/printing Storage/standby Temperature 10° to 33°C (multifunction finisher (50° to 91°F) and print cartridge) 0° to 35°C (32° to 95°F) Relative humidity 10% to 80% 15% to 90% Table 4. Acoustic emissions specifications-multifunction finisher Condition Operator position Bystander (1 m) Sound power Copying at 50 ppm Idle PowerSave LPam 57 db(A) LPam 40 db(A) inaudible LPam 60 db(A) LPam 40 db(A) inaudible LWAd 7.3 bels(A) LWAd 5.4 bels(A) inaudible Note Testing per International Standards Organization (ISO) 9296. 28 Product information ENWW