HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem ISCLI Referenc - Page 127

Table 146 Virtual Router Configuration commands Command virtual-router interface virtual-router priority virtual-router timers advertise [no] virtual-router preemption virtual-router enable no virtual-router enable no virtual-router show ip vrrp virtual-router Description Selects a switch IP interface (between 1 and 255). If the IP interface has the same IP address as the address option above, this switch is considered the "owner" of the defined virtual router. An owner has a special priority of 255 (highest) and will always assume the role of master router, even if it must preempt another virtual router which has assumed master routing authority. This preemption occurs even if the preemption option below is disabled. The default value is 1. Command mode: Router VRRP Defines the election priority bias for this virtual server. This can be any integer between 1 and 254. The default value is 100. During the master router election process, the routing device with the highest virtual router priority number wins. If there is a tie, the device with the highest IP interface address wins. If this virtual router's IP address is the same as the one used by the IP interface, the priority for this virtual router will automatically be set to 255 (highest). When priority tracking is used, this base priority value can be modified according to a number of performance and operational criteria. Command mode: Router VRRP Defines the time interval between VRRP master advertisements. This can be any integer between 1 and 255 seconds. The default value is 1. Command mode: Router VRRP Enables or disables master preemption. When enabled, if this virtual router is in backup mode but has a higher priority than the current master, this virtual router will preempt the lower priority master and assume control. Note that even when preemption is disabled, this virtual router will always preempt any other master if this switch is the owner (the IP interface address and virtual router address are the same). By default, this option is enabled. Enables this virtual router. Command mode: Router VRRP Disables this virtual router. Command mode: Router VRRP Deletes this virtual router from the switch configuration. Command mode: Router VRRP Displays the current configuration information for this virtual router. Command mode: All except User EXEC VRRP Virtual Router Priority Tracking configuration These commands are used to modify the priority system used when electing the master router from a pool of virtual routers. Various tracking criteria can be used to bias the election results. Each time one of the tracking criteria is met, the priority level for the virtual router is increased by an amount defined through VRRP Tracking. Criteria are tracked dynamically, continuously updating virtual router priority levels when enabled. If the virtual router preemption option is enabled, this virtual router can assume master routing authority when its priority level rises above that of the current master. Some tracking criteria (virtual routers, interfaces, and ports below) apply to standard virtual routers, otherwise called "virtual interface routers". A virtual server router is defined as any virtual router whose IP address is the same as any configured virtual server IP address. NOTE: VRRP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch. Configuration Commands 127