HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem ISCLI Referenc - Page 45

RIP user configuration NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch. The following command displays RIP user information: show interface ip [] rip Command mode: All RIP USER CONFIGURATION : RIP on updat 30 RIP Interface 2 : 102.1.1.1, enabled version 2, listen enabled, supply enabled, default none poison disabled, trigg enabled, mcast enabled, metric 1 auth none,key none RIP Interface 3 : 103.1.1.1, enabled version 2, listen enabled, supply enabled, default none poison disabled, trigg enabled, mcast enabled, metric 1 IP information NOTE: Layer 3 commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch. The following command displays Layer 3 information: show layer3 information Command mode: All Interface information: 1: 47.80.23.243 255.255.254.0 47.80.23.255, Default gateway information: metric strict 1: 47.80.22.1, up 2: 47.80.225.2, up vlan 1, up The following interface and default gateway information is displayed: • Interface number • IP address • IP mask • IP broadcast address • Operational status IGMP multicast group information The following table describes the commands used to display information about IGMP groups learned by the switch. Table 35 IGMP Multicast Group commands Command Usage show ip igmp groups address Displays a single IGMP multicast group by its IP address. Command mode: All except User EXEC show ip igmp groups vlan Displays all IGMP multicast groups on a single VLAN. Command mode: All except User EXEC show ip igmp groups Displays all IGMP multicast groups on a single port. interface Command mode: All except User EXEC show ip igmp groups trunk Displays all IGMP multicast groups on a single trunk group. Command mode: All except User EXEC show ip igmp groups Displays information for all multicast groups. Command mode: All except User EXEC Information Commands 45