HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem ISCLI Referenc - Page 28

Show all FDB information The following command displays Forwarding Database information: show mac-address-table Command mode: All MAC address 00:02:01:00:00:00 00:02:01:00:00:01 00:02:01:00:00:02 00:02:01:00:00:03 00:02:01:00:00:04 00:02:01:00:00:05 00:02:01:00:00:06 00:02:01:00:00:07 00:02:01:00:00:08 00:02:01:00:00:09 00:02:01:00:00:0a 00:02:01:00:00:0b 00:02:01:00:00:0c VLAN ---- 300 300 300 300 300 300 300 300 300 300 300 300 300 Port ---- 23 23 23 23 23 23 23 23 23 23 23 23 Trnk ---- 1 State ----TRK FWD FWD FWD FWD FWD FWD FWD FWD FWD FWD FWD FWD An address that is in the forwarding (FWD) state indicates that the switch has learned it. When in the trunking (TRK) state, the Trnk field displays the trunk group number. If the state for the port is listed as unknown (UNK), the MAC address has not yet been learned by the switch, but has only been seen as a destination address. When an address is in the unknown state, no outbound port is indicated. Clearing entries from the forwarding database To delete a static MAC address from the forwarding database (FDB), see the "Static FDB configuration" section in the "Configuration Commands" chapter. Link Aggregation Control Protocol information The following table describes the Link Aggregation Control Protocol information commands. Table 19 LACP information commands Command show interface port lacp aggregator show lacp show lacp information Usage Displays LACP aggregator information for the port. Command mode: All Displays LACP information for the port. Command mode: All Displays all LACP information parameters. Command mode: All Information Commands 28