HP LH4r HP Netserver LH 3000 Installation Guide - Page 102
Tighten both screws into the mounting flanges of each end of each slide.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Chapter 8 Installing the HP NetServer in the HP Rack System/E or Rack System/U 1. Hold the slide so the slide members can extend out the front of the rack. 2. Insert the slide front and rear mounting flanges between the column and bar nuts. Press the slide firmly against each rack column. Insert Mounting Flange between bar nut and rear of column. Press slide tightly against column and tighten screws to hold slide in place. Figure 8-8. Securing Slide to the Rack Column 3. Tighten both screws into the mounting flanges of each end of each slide. 4. Tighten both nuts on each slide rail to prevent the slide from slipping positions. 94
Chapter 8
Installing the HP NetServer in the HP Rack System/E or Rack System/U
94
1.
Hold the slide so the slide members can extend out the front of the rack.
2.
Insert the slide front and rear mounting flanges between the column and
bar nuts. Press the slide firmly against each rack column.
Insert Mounting
Flange between
bar nut and rear
of column.
Press slide
tightly against
column and
tighten screws
to hold slide
in place.
Figure 8-8. Securing Slide to the Rack Column
3.
Tighten both screws into the mounting flanges of each end of each slide.
4.
Tighten both nuts on each slide rail to prevent the slide from slipping
positions.