HP LH4r HP Netserver LH 3000 Installation Guide - Page 55
pipes as you insert the drive. They are very fragile.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 4 Installing Mass Storage Devices CAUTION When installing more than one drive, do not stack drives on your work surface. Hard disk drives are very susceptible to mechanical shock and can be damaged by a drop as short as one-quarter of an inch. Take care when unpacking and handling the drive. If the drop would crack an egg, it will damage the drive. 3. Drive spacers attach to the disk drive module with four small feet. Drive Spacer Figure 4-13. Removing a Drive Spacer To remove a drive spacer from a disk drive slot: a. Slide the drive spacer back, a fraction of an inch away from your body. b. Tilt up the front of the drive spacer to disengage the front two feet. c. Pull the drive spacer forward slightly to disengage the back two feet and lift. 4. Open the drive module by pressing in on the locking latch at the end of the drive ejector handle and pulling open the handle. CAUTION Be careful when you open the ejector handle. Extreme force can snap off the handle. Be careful not to damage the light pipes as you insert the drive. They are very fragile. 47