HP LH4r HP Netserver LH 3000 Installation Guide - Page 152

Chapter 13 Alternative Rack Mounting NOTE The pedestal HP NetServer LH 3000 cannot be rack installed without a conversion kit. Contact your HP reseller for information about the HP NetServer LH 3000 to LH 3000r Conversion Kit. Rack-mounting Guidelines and Precautions Observe the following guidelines and safety precautions during the rack-mount installation. l Extend the rack's anti-tip foot prior to any work on the rack to prevent rack tip-over, equipment damage, and injury. WARNING Lower the leveler feet at the four corners of the rack to improve stability and prevent the rack from rolling away as devices are inserted into their rack mounts. Failure to use the anti-tip foot and leveler feet could result in serious injury. l Uneven mechanical loading within the rack can cause hazardous conditions. Plan the placement of equipment in the rack to make sure that this problem does not occur. ◊ Install components from the bottom up. ◊ Place the heaviest components on the bottom of the rack. CAUTION If other rack components are to be mounted in the rack below the HP NetServer, install those components before starting to mount the NetServer. ◊ Use HP Rack Assistant to plan the rack configuration and to check power, weight, and stability of the configured rack. Download HP Rack Assistant from: http://www.hp.com/netserver/servsup l Install components such as DIMMs and processors into the system board assembly before rack-mounting the NetServer. l Remove power supplies and hard drives before lifting the NetServer. 144