HP LH4r HP Netserver LH 3000 Installation Guide - Page 67
Installing Additional PCI Boards
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
6 Installing Additional PCI Boards Introduction This chapter describes how to install accessory boards, during initial installations, into the I/O board. The I/O board is under Cover 1 on the top of the LH 3000r and under the left cover of the LH 3000. If you want to do a "hot" add or "hot" replacement (with the HP NetServer powered up), go to Hot Adding or Replacing Hot-Plug PCI Boards at the end of this chapter. Remote Integrated NetRAID Memory Management SE SCSI Slots 1- 4 Non-hot-plug Slots 1- 6 +5V 33 MHz/64 Bit SCSI A Slots 5- 8 Hot-plug Slots 7 and 8 Universal 33 MHz/64 Bit SCSI B Power LEDs Attention LEDs Figure 6-1. I/O Board Slots 1 through 6 support +5 volt PCI boards. Slots 7 and 8 support +3.3 volt, +5.0 volt or Universal PCI boards. All eight slots accept 64-bit PCI boards. Slots 5 through 8 are hot-plug enabled. 59