HP LH4r HP Netserver LH 3000 Installation Guide - Page 157
screw holes marked earlier. Start but do not tighten two screws through
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Chapter 13 Alternative Rack Mounting Installing Bar Nuts The "bar nut" is a two-hole metal bar used to secure the mounting flanges of the slide to the front columns. Place bar nut behind outside face of column. Start two screws in bar nut but do not tighten. Figure 13-4. Installing Bar Nuts 12. Hold the bar nut behind the outside face of the front column, at the slide screw holes marked earlier. Start (but do not tighten) two screws through the face of the into the bar nut. 13. Install the bar nuts on both front columns. 149
Chapter 13
Alternative Rack Mounting
149
Installing Bar Nuts
The "bar nut" is a two-hole metal bar used to secure the mounting flanges of the
slide to the front columns.
Place bar nut
behind outside
face of column.
Start two screws
in bar nut but do
not tighten.
Figure 13-4. Installing Bar Nuts
12.
Hold the bar nut behind the outside face of the front column, at the slide
screw holes marked earlier. Start (but do not tighten) two screws through
the face of the into the bar nut.
13.
Install the bar nuts on both front columns.