HP LH4r HP Netserver LH 3000 Installation Guide - Page 158
slide in an HP systems rack.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Chapter 13 Alternative Rack Mounting Attaching the Slides The following steps describe how to attach the slides to the columns. 14. Remove the removable mounting flange. A large, flat-blade screwdriver inserted between the flange and the slide from the end of the slide may help in removal. This mounting flange is not required when installing a slide in an HP systems rack. 15. Remove hex nuts and lock washers securing the removable mounting flange to the slide. Save the hex nuts and lock washers. 16. Hold the slide so the slide members extend out the front of the rack (see Figure 13-5). 1. Note the removable mounting flange has been removed. 2. Insert two screws through the front column and start the screws in a bar nut. 3. Use hex nut and lock washer to fasten slide to inside face. 4. Insert the slide in place behind the column face but in front of the bar nut. Figure 13-5. Attaching the Slides 150