HP LH4r HP Netserver LH 3000 Installation Guide - Page 14
Configuring the HP NetServer
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Chapter 1 Setting Up the HP NetServer LH 3000r and LH 3000 10. Replace covers and the bezel. Refer to Chapter 3, "Opening and Closing the HP NetServer." 11. Connect the monitor, keyboard, mouse and power supplies. Refer to Chapter 9, "Connecting Monitor, Keyboard, Mouse, and Power Supplies." 12. Connect external cables. 13. Power up the HP NetServer. Refer to Chapter 2, "Controls, Ports, and Indicators." Go to the next section, "Configuring the HP NetServer." Configuring the HP NetServer XXXX Document Number Figure 1-4. Navigator CD-ROM 1. Load the HP Navigator CD-ROM. Place the HP NetServer Navigator CD-ROM in the drive and close the drive. NOTE To fully configure the HP NetServer, all the rack components must be cabled and online (though not necessarily installed in the rack). Refer to Chapter 10, "Configuring the HP NetServer." 6