HP LH4r HP Netserver LH 3000 Installation Guide - Page 76
Removing a Hot-Plug Board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Chapter 6 Installing Additional PCI Boards Removing a Hot-Plug Board If you want to remove or replace a hot-plug PCI board, go to "Hot Adding or Replacing Hot-Plug PCI Boards" in the following section. To remove a hot-plug board from the HP NetServer which is not running: 1. Make sure power is off and follow the instructions for accessing the I/O board. 2. Pull the brown plastic slot separator out until you feel resistance (about three-eighths of an inch, or 10mm). This releases the hot-plug board from the connector. Figure 6-5. Removing a Hot-Plug Board 3. Remove the hot-plug board. 4. Either replace the hot-plug board or reinstall the slot cover. NOTE To perform a hot add, or a hot-plug board installation when the HP NetServer is powered up, refer to "Information Assistant" on the HP NetServer Online Documentation CD-ROM. 68