HP ProLiant DL380G5-WSS 3.7.0 HP StorageWorks HP Scalable NAS File Serving Sof - Page 154

The utility can be used with either psd or psv devices. Use this syntax to specify the device: • For a psd device partition, the device is specified as /dev/psd/psdXXXpYY, where XXX is the drive number and YY is the partition number. For example, / dev/psd/psd6p4 specifies partition 4 on disk psd6. • For a non-partitioned psd device, the device is specified as /dev/psd/psdXXX, where XXX is the drive number. For example, /dev/psd/psd5. • For a psv device, the device is specified as /dev/psv/psvXXX, where XXX is the volume number. For example, /dev/psv/psv1. This program does not change the size of the partition containing the filesystem. Instead, you will need to use a utility specific to your RAID subsystem to modify the size of the partition. You will need to deport the disk containing the filesystem before you modify the partitions. CAUTION: Be sure to back up your data before using this program. You can use the -s option to specify the new size for the filesystem. If you do not specify the size, the filesystem will grow to the size of the partition. The -s option can be used as follows. • Specify the size in kilobytes, megabytes, gigabytes, or terabytes: -s size[K|M|G|T] • Specify the amount (in kilobytes, megabytes, gigabytes, or terabytes) by which the filesystem should be increased: -s [+]size[K|M|G|T] The following example increases the size of the filesystem by 1 GB. resizepsfs -s +1G /dev/psd/psd6p4 NOTE: If you do not specify any options, resizepsfs will try to resize the filesystem to the full size of the partition. The -q option prints only error messages. 154 Configure PSFS filesystems