HP ProLiant DL380G5-WSS 3.7.0 HP StorageWorks HP Scalable NAS File Serving Sof - Page 267

Start replication Replication must be enabled before it can be restarted. You may need to enable replication on one or more nodes and on the cluster itself, depending on the replication state. Use the rplstatus command to determine the cluster replication status and the node replication status. • If replication is running on the cluster (cluster replication status 2), but is stopped or exited on one or more nodes, enable replication on the affected nodes. You can then restart replication on those nodes. For example, to enable replication on a node, run the following command: # rplcontrol -s enable [-h ] To restart replication, simply restart HP Scalable NAS on the affected nodes. If replication was stopped across the cluster, you will need to restart HP Scalable NAS on each node. # /etc/init.d/pmxs start • If replication is in state 5 (exited) on the cluster or the nodes, you will need to enable the global cluster replication state and also enable replication on the nodes. You can then restart replication on the nodes. See Restart replication when it is not running on the cluster, below, for an example. Restart replication when it is not running on the cluster If rplstatus reports that replication is not running on the cluster (for example, the status is "5 (exited)"), you will need to enable both the global cluster status and the replication status on individual nodes and then restart replication. Complete these steps: 1. Run the following command on each node to enable replication: # rplcontrol -s enable -h 2. Set the global cluster state to enabled: # rplcontrol -s enable 3. Restart HP Scalable NAS on each node: # /etc/init.d/pmxs start Stop all replication programs Use this command to stop replication completely on all nodes: HP Scalable NAS File Serving Software administration guide 267