HP ProLiant DL380G5-WSS 3.7.0 HP StorageWorks HP Scalable NAS File Serving Sof - Page 260

#interval interval 120 #Preferred Sentinel #sentinel sentinel 99.30.35.6 #Note: In current version, only one preferred sentinel should be specified After creating the file and entering the replication information, run the following command to omport the configuration file into the mxds datastore. # rplconfig -i NOTE: An error will be reported if ssh connections to the destination cluster were previously made for the virtual host IP address. Remove those entries from /root/.ssh/ known_hosts on the node. See Correct the known.hosts file, page 256 for more information. Duplicate the source filesystem layout on the destination cluster You may want the filesystem layout on the destination cluster to match the layout on the source cluster. To do this you will need to create the appropriate filesystems under the target on the destination cluster. For example, you could have two PSFS filesystems, /mnt/poly0/ and /mnt/poly1/, on the source cluster. On the destination cluster, create and mount the same PSFS filesystems: /mnt/poly0/ and /mnt/poly1/. Then, in the replication configuration file, add an entry for each filesystem and use / as the target. replicate replicate /mnt/poly0/ /mnt/poly1/ 99.30.252.40 / 99.30.252.40 / The replicated files will now be placed in the appropriate filesystem on the destination cluster. How replication works When replication has been configured, the rplmonitor program manages and coordinates the replication components running on the nodes in the source cluster. It is started by HP Scalable NAS and has two major roles: to start the rplwatch process (which starts worker threads) and then restart the worker threads if necessary, 260 Configure and manage replication