HP ProLiant DL380G5-WSS 3.7.0 HP StorageWorks HP Scalable NAS File Serving Sof - Page 257

Offending key in /root/.ssh/known_hosts:12 RSA host key for 10.30.12.4 has changed and you have requested strict checking. Host key verification failed. To correct this problem, edit the /root/.ssh/known_hosts file, remove the offending line, and attempt the ssh again. Configure replication for a node IP on the destination cluster Complete these steps: 1. Create the administrative filesystem on both the source and destination clusters if it does not already exist. See Create the administrative filesystem, page 139. 2. Use the following command to install the ssh key pair on the source and destination clusters. (The first time rplkeys is run, it may prompt for the remote password if the host fingerprint for the destination node is not in ~root/.ssh/ known_hosts on the source cluster.) # rplkeys 3. Create and import the replication configuration file as described under Create the replication configuration file, page 257. 4. On the nodes in the source cluster, restart HP Scalable NAS, which starts replication. /etc/init.d/pmxs start 5. Run the following command to verify that replication is running. rplstatus NOTE: After replication has been started, do not change the path for the administrative filesystem on either the source or destination cluster. If it is necessary to change the path, you will need to stop replication, make the change, and then restart replication. Create the replication configuration file The replication configuration file is stored in the mxds datastore on the membership partitions. To create the file, run the following command. You can call the file whatever you want. HP Scalable NAS File Serving Software administration guide 257