HP ProLiant DL380G5-WSS 3.7.0 HP StorageWorks HP Scalable NAS File Serving Sof - Page 359

• The mprepair command can be used to display information about membership partitions and to perform all operations affecting membership partitions. HP Scalable NAS must be offline on all nodes when this command is used. Online operations When HP Scalable NAS is running, the Add, Repair, and Replace options on the Storage Settings tab and the mx config mp set and repair commands can be used only in the following circumstances: • A disk containing a membership partition is out-of-service. Use the replace option or mx config mp set to move the partition to another disk. • You need to move one or more membership partitions to different storage. Use the replace option or mx config mp set to move the partitions one-at-a-time. • In a cluster with three membership partitions, when HP Scalable NAS started on a server, it reported that a single membership partition was corrupt. Use the repair option or mx config mp repair to resilver the partition. You can also replace the partition with the replace option or mx config mp set. • Your cluster contains a single membership partition and you want to add two more partitions. Use the add option or mx config mp set. • While the cluster is running, two membership partitions are reported to be corrupt. Use the repair option or mx config mp repair to resilver the partitions. You can also replace the partition with the replace option or mx config mp set. IMPORTANT: HP Scalable NAS must be offline on all nodes when performing all other membership partition operations. Options on the Configure Cluster window If the HP Scalable NAS Management Console is running, select Tools > Configuration Utility to display the Configure Cluster window. If the console is not running, open the HP Scalable NAS Connect window, provide your connection information, and select Configure. The membership partition options are on the Storage Settings tab. HP Scalable NAS File Serving Software administration guide 359