HP SW TL881 DLT Mini-Lib/1 Compaq TL881 MiniLibrary System Users Guide (May 19 - Page 144
Control Error Codes - 2xxx, Ctl Invalid Command, Invalid Drive State, Loader Not Ready
View all HP SW TL881 DLT Mini-Lib/1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Diagnostics and Troubleshooting 6-9 Table 6-2 Fault Symptom Codes continued Control Error Codes - 2xxx 2001 Ctl Invalid Command Ctl. Invalid Command 2002 Undefined Config An unsupported configuration was detected. 2003 Invalid Drive State One of the DLT drives was in an invalid state This is caused by either attempting to fetch a cartridge from an empty drive, or stowing to a drive that already has a cartridge loaded. 2004 Loader Not Ready Currently not displayed. 2005 SCSI Id Not Set An attempt to set the DLT SCSI id failed. 2006 DLT Comm Open Error An attempt to open a COM port failed. 2007 Door Fault An error occurred while attempting to move the door. 2008 Illegal Move While attempting to perform a MOVE operation, the source or destination locations were in the wrong state (FULL or EMPTY).This also occurs if the MOVE is attempted with an invalid cartridge map. 2009 Door Open A command was received while the door was open. 200A Menu Mode A command was received while the unit was in Menu mode. 200C Cart Unaccessible An attempt was made to fetch a cartridge from a drive that is not in the unloaded state. This only applies when the system is configured for explicit unloads. 200D Drive In Error An attempt was made to access a drive which is in an error state. 200E No Magazine The element is not available because the magazine is not installed. continued