HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 113

Exporting Data Cartridges through the CAP To export data cartridges through the CAP: 1. Press the [CAP A] or [CAP B] button on the operator panel to open the CAP. 2. Remove or pull down the magazine and remove the cartridges and store them outside the tape library. 3. Repeat these steps until you have removed all the required cartridges. 4. Press the [CAP] button to close the CAP 5. Refer to your console and your software documentation for further instructions. Manually Cleaning a Drive If you have not enabled the Auto Clean function on the library, then the library status screen will display CLEAN NEEDED whenever a drive requires cleaning. To manually clean this drive: 1. Press the [CAP] button on the operator panel to open the CAP. 2. Insert the required cleaning cartridge into the CAP. 3. Press the [CAP] button to close the CAP. 4. Press the [MENU] button until the Main Menu displays. 5. Press the arrow buttons until the cursor underscores DIAGNOSTICS. 6. Press the [SELECT] button. The panel displays the Main Diagnostics Menu (see Figure 13 on page 49). 7. Press the arrow buttons until the cursor underscores DRIVE DIAGNOSTICS. 8. Press the [SELECT] button. The screen will display a list of all installed drives. 9. Use the arrow buttons to highlight the desired drive. 10. Press the [SELECT] button. The Diagnostics Drive Menu appears. 11. Press the arrow buttons until the cursor underscores CLEAN DRIVE. 112 Operating in Automated Mode Chapter 4