HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 83

Setting the IP Address The system administrator might assign the library an IP address, which makes the library accessible through a network. This is a four-byte address that must be set with information obtained from the system administrator. The value set identifies the library and makes it accessible through a network. An example of an IP address entry is 192.0.0.1 Note To use the Web-Based Library Administrator, you must set the library's IP address at the operator panel. To set the IP address: 1. At the Network Config Menu, press an arrow button until the cursor underscores LIBRARY NAME. 2. Press the [SELECT] button. An editing screen appears. 3. On the editing screen: a. Use the up and down arrow buttons to select a value for each threedigit field in the address. Note Do not leave the first field equal to zero (000). b. Use the [SELECT] button to move right to the next field. c. Use the [MENU] button to move left to the previous field. 4. When the screen displays your desired setting, press the [SELECT] button from the right-most field to save the changes. You may press the [MENU] button from the left-most field to abort. 5. If you have already changed the library's SCSI ID and are planning to exit the main Configuration Menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section. If you have not changed the library's SCSI ID and are not setting other configuration values, press the [MENU] button until you exit all menus. 82 Entering Configuration Data Chapter 3