HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 19
Storage Cells, Cell Locations
View all HP Surestore Tape Library Model 20/700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Storage Cells The library contains storage cells for 228 to 690 cartridges, excluding the CAP cells. The number of cells is determined by how many drives are installed and whether the tape library has the standard rear window panel or the expansion frame. The expansion frame provides additional storage cells for 294 cartridges. Cell Locations Cartridges are stored in cell arrays that hold six cartridges. Cell arrays are stacked in columns and these columns are arranged in a circle around the robot assembly. Columns can hold up to 42 cartridges. Table 1 on page 20 lists tape library storage capacities. Figure 3 on page 21 through Figure 4 on page 22 show cell locations for the 20/700 tape library in its various configurations. Note The following statements apply to cell locations: 1. The library uses array targets for robotic calibration during an Initial Program Load (IPL). 2. Never put data cartridges in the reserved cells (refer to Figure 3 on page 21 for more information). If you do not want to store diagnostic and/or cleaning tapes in these cells, you must leave them empty. 3. The library does not use the drive and CAP locations to store cartridges. 4. The robot uses the swap cell (the top-most cell in the reserved area) for intransit cartridges, to place a cartridge that is left in the hand-camera assembly when a power failure occurs, or to perform a swap operation. 18 Tape Library Components Chapter 1