HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 117

Running Drive Diagnostic Tests To run a diagnostic test on a drive: 1. Ensure the library is not in use. 2. Press the [MENU] button until the Main Menu displays. 3. Press the arrow buttons until the cursor underscores DIAGNOSTICS. 4. Press the [SELECT] button. The panel displays the Main Diagnostics Menu. 5. Press the arrow buttons until the cursor underscores DRIVE DIAGNOSTICS. 6. Press the [SELECT] button. The screen will display a list of installed drives. 7. Use the arrow buttons to highlight the desired drive. 8. Press the [SELECT] button. The Diagnostics Drive Menu appears. 9. Press the arrow buttons until the cursor underscores the desired test. For a description of the available tests, see Table 12 on page 115. 10. Press the [SELECT] button. If you selected MOUNT/DISMOUNT LOOP, an editing screen will appear: a. Use the arrow buttons to enter the desired value. (The up arrow button increases the value; the down arrow button decreases the value.) b. Press the [SELECT] button. 11. You will be prompted to confirm that you want the library in Maintenance Mode (offline) before beginning the test (ARE YOU SURE?). Confirm this by pressing the [SELECT] button. (You may press the [MENU] button to abort.) 12. Wait until the test is completed; the screen will display a message that either the test completed successfully or, if a problem occurred, the screen will display an error message and, in some cases, an FSC code. 116 Operating in Automated Mode Chapter 4