HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 77

Drive Entries Note For 9840 drives only: The drive's SCSI ID and bus status can be entered from the library's operator panel if the drive has firmware version 1.24 or higher. Check the drive's firmware version, by selecting DRIVE INFO from the Main Menu. Configuring a 9840 drive might involve more than setting the drive's SCSI ID and bus status. For more information about 9840 drive configuration options and instructions, refer to the 9840 Tape Drive Service Manual. Two entries complete the configuration options for each SCSI drive: I SCSI ID I Bus status (on or off bus) Note "On Bus" means that the drive is on the same SCSI bus as the library. "Off Bus" means that the drive is not on the same SCSI bus as the library. Set the drive SCSI IDs and bus status from the drive configuration menu. You can enter both values for each drive at the same time: 1. At the main Configuration Menu, press an arrow button until the cursor underscores DRIVE CONFIG. 2. Press the [SELECT] button. The screen will list all installed drives, and the cursor will align with the first drive on the list. An example of the format is: 00 HP LTO ID: 01 ON BUS: ON The first two digits are the drive's logical number (the number that the library has assigned the drive). The tape library sets this number during its automatic configuration sequence (at power-on or reset). It is an internal number only and is shown for information only. 76 Entering Configuration Data Chapter 3